What an AAWG does in a DWDM transport link

Applications · Notes

What an AAWG does in a DWDM transport link

Forty wavelengths on one fiber, produced by a passive pair of arrayed waveguide gratings.

AAWG multiplexing link with transceivers, EDFA and fiber span
Fig. 2 A 40-channel 100 GHz mux / demux pair, passive at both ends

How the link runs

Each transceiver emits one wavelength. The multiplexer combines them into a single fiber; erbium-doped fiber amplifiers (EDFA) make up the span loss on long routes; at the far end a pre-amplifier feeds the demultiplexer, which separates the 40 wavelengths back to individual receivers.

The important part: both MUX and DEMUX are passive. No power, no heat, no management port. The reliability of the whole system rests on these two silent components, and when one fails, all forty channels fail together.

Four numbers that decide the part

  • Insertion loss: typically 4-6 dB, and the link budget must use the worst channel, not the average
  • Channel spacing: 100 GHz means 0.8 nm and 40 channels; 50 GHz doubles that but tightens the process
  • Temperature behaviour: athermal types keep the grid stable across the operating range, mandatory for outdoor cabinets
  • Flatness and isolation: cascading several stages, gaussian and flat-top profiles behave differently, so do not mix them

When CWDM is the better answer

Not every link needs DWDM. Metro access and campus interconnect under about 15 km with eight channels or fewer are cheaper and lower-loss with CWDM modules, which also need no temperature control. DWDM earns its cost through channel count and long-haul amplification; forcing it onto a short link only wastes budget.

Related products: AWG modules · CWDM / DWDM modules · Isolators & PM components

Scroll to Top